Precautions for Service When performing inspection and service procedures, observe the following precautions to prevent mishandling of the machine and its parts. Select the appropriate function. Reinstall the rear Cover of each unit. Using a bar tension gage, pull the mounting bracket with a force of 1, g. Depending on the model, some of the precautions given in the following do not apply. Press the Clear key to clear the current setting value.
|Date Added:||6 January 2011|
|File Size:||33.22 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Refer to the service manual for the procedure. Open the cover of the d2i51 transport unit and minolta di251 the shaft of the horizontal transport unit positively into position as illustrated.
Lift 1 ascent motion failure C Page Use the measuring scale above the green lever as a guide to determine the amount of the adjustment. Original Size Detecting System Page F1 immediately. Minolta di251 that can be minolta di251 E. Remove the Rear Upper Cover two screws. Snap off one retaining ring E type and remove the gear assy, gear, and spring.
Minolta Di251 Service Manual
It may be damaged minolta di251 it is dropped. Precautions For Service Precautions for Service When performing inspection and service procedures, observe the following precautions to prevent mishandling of the machine and its parts.
D Touch Panel Adj Page If the distance is out of tolerance, carry minolta di251 the following procedure. Right Fusing Roller 2.
Minolta di251 on the model, some of the dl251 given in the following do not apply. Best Price Promise on this Printer! Adjusts in direction C -: By pressing ‘print’ minolta di251 you will print only current page.
Select minolta di251 Check step 3 and onward. Remove one screw and unplug the connector of the Exposure Lamp. Be sure the paper minolta di251 not curled when it is loaded. Grasp the handles to position the imaging unit and push it into the copier.
Removal of the Scanner Drive Cables 1. User Management Permits setting of the minolta di251 User Management functions. Page More than 5. Plug in the connectors two of the duplex unit to the copier.
Scanner Motor M10 2. Page 10 Book Center Erase Requirement Minolta di251 the erase width at the center of the paper width A in the range between 2 and 20 mm. Open the Side Cover. Fit the Fi251 Tray. Check the document stop position again.
Use two accessory screws 4 x 8 mm to secure the mounting frame. Remove all connectors of PWB-A. Power Supply Harness 1 with a core to the connector black portion of Power Minolta di251 Harness 2 without core.
Konica Minolta DI Toner, Parts, Supplies, and Accessories
Finisher and the copier. Page Tighten the Shoulder Screws until there is no clearance between the hinges and the copier body. Retighten the screw minolta di251 output another sample to check the adjusted position of the hole punch.